WHO WE ARE
ABOUT US
We are a well-known manufacturer of hairbrushes and combs in Malaysia since 1993. Dosca Sdn Bhd offers an extensive choice of over 1000 hair care products. Our factory is located in Masai, Johor, Malaysia. We are famous for our wide range of hairbrushes and accept order of hairbrushes for any hair type, length, and budget. We specialize in salon hairbrushes, plastic combs, crystal combs, etc.
SERVICE
.png)
original equipment manufacturer
.png)
original design manufacturer
.png)
original brand manufacturer
we sell in malaysia and singaporePRODUCTION
MAIN DEPARTMENT:
PLASTIC INJECTION
Plastic injection molding is the process of plastic injection into a mould. The plastic is injected into the brush mould and held under pressure for a specified time, which may be milliseconds or minutes. After the injection is completed, packing pressure is applied to make sure that the component sets after it is injected.
BRUSH BRISTLE TUFTING
A hairbrush can also additionally encompass a frame having a receiving component at the primary end. A cushion pad having an internal floor and an outer floor can be disposed withinside the receiving component and can encompass a plurality of bristle anchors having an aperture. A plurality of bristles can be tufted into every of the apertures.
PRINTING DEPARTMENT
The electrochemical process creates a brush mold of a type of surface that then forms a flat or curved plate. To prepare them for printing, they must be routed or planed to a suitable thickness. The printing surface of these materials is the foundation of a publication.
